Sega House of the Dead Owner's Manual download pdf (Page 63)

www.seuservice.com

In the cases where the gun's operation is not satisfactory or the gun sight deviates from the

direction in which the control unit is pointed, the gun's interior parts may have been damaged.

Replace the parts by disassembling the gun in the following procedure: Also, be sure to perform

sighting check in the test mode when the gun parts are replaced.

To replace parts in the Shotgun, it is necessary to separate the two halves of the outer case cover.

Internal parts are inserted directly into the right side of the cover, so the procedure should be

carried out with the right half downmost.

 Turn the power OFF.

 Remove the 2 BIND screws from each side and remove the left and right Slide Grips.

 To separate the left and right halves of the cover, remove the 3 (M3×8) screws and the 12

(M3×16) screws. Be aware that 1 (M3×16) screw is in the right side of the cover. Therefore,

remove the 1 screw on the right half of the cover rst, before removing the rest of the screws,

with the right half downmost.

 Do not cut the tie belt securing the wires in the Control Unit (Shotgun).

Cutting the tie belt may cause malfunctioning of the wire connection. If you

cut the tie belt when replacing the wire etc., be sure to secure the wires using

a new tie belt as before.

 After removing 4 bind screws once, retighten them by using the designated

threadlocking agent (Part Number: 090-0012). If the threadlocking agent is

not used, the reassembled shotgun may rattle or come apart.

 Use only the threadlocker designated in this manual. Use of other

threadlocking agents may cause chemical reactions that could damage the

screws or part's surface.

8. CONTROL UNIT (SHOTGUN)

 In order to prevent an electric shock and short circuit, be sure to turn power

off before performing work by touching the interior parts of the product.

 Be careful not to damage the wires. Damaged wires may cause electric shock

or short circuit or present a re risk.

 Be very careful when soldering. Handling a soldering iron carelessly may

result in a re or a burn.

When securing the plastic-made parts, do not excessively fasten screws and nuts.

Failure to observe this may damage the parts and cause injury due to fragments

resulting from damage.

REPLACING THE MICROSWITCH

CAUTION!

STOP

IMPORTANT!

WARNING!

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 79 80

No comments

Sega House of the Dead Owner's Manual Page 63